Difference between revisions of "How to Measure a short end-straight with a flange"
From ATTWiki
(→Step 3 - Straight Measure) |
(→Step 3 - Cylinder Fit Error) |
||
Line 82: | Line 82: | ||
</td> | </td> | ||
<td width=300> | <td width=300> | ||
− | [[image:vtube- | + | [[image:vtube-laser_cylinderfit_accuricies_dialog.jpg|300px]] |
</td> | </td> | ||
</tr> | </tr> | ||
</table> | </table> | ||
<br><br> | <br><br> |
Revision as of 19:18, 19 May 2011
Back to VTube-LASERHow to Measure a Short End Straight with a Flange in VTube-LASER
|
Difficult End Flanges
End flanges can cause challenges when a bend is coming out of the flange. There is no first straight available where the tube comes out of the flange. |
Step 1 - End Scan
Start the TUBE measure feature in the MEASURE PROCESS menu, then switch the laser off for the end-scan use the ball probe to collect the end of the tube. |
Step 2 - Straight Measure
When measuring the straight, switch the laser off again. Probe the inside of the cylinder as shown here.
|
Step 3 - Cylinder Fit Error
When measuring a short straight like this, the cylinder fit error window will most like display. This is normal as the straight is so short.
|