Difference between revisions of "How to Measure a short end-straight with a flange"
From ATTWiki
(→End Flanges) |
(→Difficult End Flanges) |
||
Line 20: | Line 20: | ||
== Difficult End Flanges == | == Difficult End Flanges == | ||
− | + | [[image:vtube-laser_endflange_image1.jpg|300px]] | |
<table> | <table> | ||
<tr> | <tr> | ||
Line 27: | Line 27: | ||
</td> | </td> | ||
<td width=300> | <td width=300> | ||
− | [[image:vtube- | + | |
+ | [[image:vtube-laser_endflange_image2.jpg|300px]] | ||
</td> | </td> | ||
</tr> | </tr> |
Revision as of 18:17, 19 May 2011
Back to VTube-LASERHow to Measure a Short End Straight with a Flange in VTube-LASER
|
Difficult End Flanges
End flanges can cause challenges when a bend is coming out of the flange. There is no first straight available where the tube comes out of the flange. |