Difference between revisions of "How to Measure a short end-straight with a flange"
From ATTWiki
(→Minimum Screen Resolution) |
(→End Flanges) |
||
Line 20: | Line 20: | ||
== End Flanges == | == End Flanges == | ||
− | |||
− | [[image:vtube-laser_endflange_image1.jpg| | + | <table> |
− | < | + | <tr> |
+ | <td width=300> | ||
+ | End flanges can cause challenges when a bend is coming out of the flange. There is no first straight available where the tube comes out of the flange.<br><br> | ||
+ | </td> | ||
+ | <td width=300> | ||
+ | [[image:vtube-laser_endflange_image1.jpg|300px]] | ||
+ | </td> | ||
+ | </tr> | ||
+ | </table> | ||
<br><br> | <br><br> | ||
Revision as of 18:11, 19 May 2011
Back to VTube-LASERHow to Measure a Short End Straight with a Flange in VTube-LASER
|
End Flanges
End flanges can cause challenges when a bend is coming out of the flange. There is no first straight available where the tube comes out of the flange. |