Difference between revisions of "How to Install a MOXA Device Driver in Windows"
From ATTWiki
(→Programming the MOXA from the factory) |
(→Programming the MOXA with FACTORY Settings) |
||
Line 22: | Line 22: | ||
# Plug a standard patch cable from the setup computer to the MOXA device.<br><br> | # Plug a standard patch cable from the setup computer to the MOXA device.<br><br> | ||
− | # Set the IP address of the computer port to 192.168.127.1<br><br> | + | # Set the IP address of the computer port to 192.168.126.1 (Some MOXA devices use 192.168.127.254 for the initial network setup. If .126 does not work, then you can try 192.168.127.1 and ping for 192.168.127.254 in the cmd box.)<br><br> |
− | # Load an internet browser and type "192.168. | + | # Load an internet browser and type "192.168.126.254" (per the note above, some use 192.168.127.254) in the address box and press Enter.<br><br> |
# The MOXA setup page should display. Click on Network Settings.<br><br> | # The MOXA setup page should display. Click on Network Settings.<br><br> | ||
# Change the IP address to the new network scheme. (Often with this format: 192.168.1.nnn, were "nnn" is any number from 2 to 254)<br><br> | # Change the IP address to the new network scheme. (Often with this format: 192.168.1.nnn, were "nnn" is any number from 2 to 254)<br><br> |
Revision as of 19:46, 5 November 2016
Use this video to learn how to install a MOXA device driver for connection to a bender for linking to a virtual COM port through a network.
|
Programming the MOXA with FACTORY Settings
Follow these steps to program a MOXA NPort with factory settings (the videos above assume that this has already been performed).
|