Difference between revisions of "How to Check for a Hardware Key"

From ATTWiki
Jump to: navigation, search
(Step 3 - Plug in the Hardware Key and Run the KeyCheck Program)
Line 80: Line 80:
 
</td>
 
</td>
 
<td>
 
<td>
 
+
[[image:keycheck_v7.42.jpg|300px]]
 
+
 
</td>
 
</td>
 
</tr>
 
</tr>
 
</table>
 
</table>

Revision as of 14:12, 12 April 2012

Keycheck logo.jpg

This describes how to check for a hardware key.

Keycheck v7.42.jpg


Contents

Step 1 - Is the Hardware Key Driver Installed?

The hardware key driver must be installed for the key to be used on your system. If necessary, download and install the driver.

If you know that you have installed the hardware key driver on your system at least one time, then skip to step 2. If you are not sure, then it is okay to install the driver again.

Step 2 - Locate or Download the KeyCheck Program

Find the keycheck.exe program. Often this program is installed with any Advanced Tubular software that uses a hardware key. If you cannot find it, then please download an installation file and install the keycheck program.

Step 3 - Plug in the Hardware Key and Run the KeyCheck Program

Plug in the key. The key will look like one of the two shown on the right.

If the hardware driver is installed on the computer, then a light will switch in the key. (Both keys have an LED light to indicate they are active.)

Permanent Key (no expiration)

Hasp hl pro.jpg

Time-Limited Key (expires)

Hasp hl time.jpg

Step 4 - Run the KeyCheck Program

Run the hardware key program on the system with the key plugged in. It should find the key are report how the key is setup in the log on the screen.

If the key is not found by the KeyCheck program, then please contact us for further assistance.

Keycheck v7.42.jpg