How to Adjust the VTube License Type in the Config File

Back to the Main VTube-LASER web page Back to VTube-LASER Knowledgebase Page

Steps to Adjusting

This table is highly recommended. This table was installed for a customer that asked for a turnkey solution. The table is 6" thick. (The other model is 12" thick.) The customer determined that the 6" thick table was better because the final height was 6" lower. The table top height is 34". Part Number: INT1-46-6-N Web site: www.newport.com Note: We do not recommend the 12" table, as it is 40" from the floor, which makes it too high for some operators.

FARO Magnetic Base

Step 1 Explore into your configuration path using this utility program Step 2 Open the “vtube local settings.cfg” file in that window in a notepad type editor. Step 3 Move down through the file until you find the line that starts with “License Type=” Step 4 It should read like this: “License Type=Laser”. Step 5 Change whatever you find after the equal sign to “Laser”. Step 6 Save the cfg file. Step 7 Open VTube

Other Pages

• Back to VTube-LASER