Difference between revisions of "How Do I Install CNC Bender On a New Computer?"
(→HOW TO INSTALL CNC BENDER to A NEW COMPUTER) |
(→HOW TO INSTALL CNC BENDER to A NEW COMPUTER) |
||
Line 16: | Line 16: | ||
Follow these steps to setup CNC Bender on your new computer. | Follow these steps to setup CNC Bender on your new computer. | ||
− | + | ||
− | + | ||
+ | <table cellpadding="15" width = 650> | ||
+ | <tr valign="top"> | ||
+ | |||
+ | <td bgcolor="#f0f0f0" width = 200> | ||
+ | <font size=4><b>STEP 1</b></font> | ||
+ | ----<br> | ||
+ | Close | ||
+ | </td> | ||
+ | <td bgcolor="#e3e4f5"> | ||
Close CNC Bender software on the operator station that you want to duplicate. | Close CNC Bender software on the operator station that you want to duplicate. | ||
+ | [[image:flashdrive.jpg|thumb|USB Flash Drive]] | ||
+ | </td> | ||
+ | </tr> | ||
− | + | <td bgcolor="#f0f0f0" width = 200> | |
+ | <font size=4><b>STEP 2</b></font> | ||
+ | ----<br> | ||
+ | Close | ||
+ | </td> | ||
+ | <td bgcolor="#e3e4f5"> | ||
Plug a USB FLASH DRIVE[http://en.wikipedia.org/wiki/USB_flash_drive] into the operator station. (You will need a FLASH DRIVE with about 100 Megabytes of free memory.) | Plug a USB FLASH DRIVE[http://en.wikipedia.org/wiki/USB_flash_drive] into the operator station. (You will need a FLASH DRIVE with about 100 Megabytes of free memory.) | ||
+ | |||
+ | </tr> | ||
+ | |||
+ | </table> | ||
+ | |||
# Browse to the C:\CNC folder on the operator station using Windows Explorer. | # Browse to the C:\CNC folder on the operator station using Windows Explorer. |
Revision as of 19:50, 5 March 2007
Contents |
DESIGN
CNC Bender is designed to be easy to setup on most computers in your office . Nearly any Windows computer with a TCP/IP connection will work.
This means that you can run CNC Bender on nearly any laptop or desktop computer in your office. See the steps below for step by step instructions on how to install CNC Bender to any compatible computer.
LICENSE
What about licensing requirements? Our licensing requirements are very simple because the license is tied to a device we call a "hardware key." If you have the hardware key, then you are permitted to run CNC Bender. This means that you can copy CNC Bender software to as many computers as you wish. In fact, I recommend that you make at least one working backup copy for emergency recovery.
HOW TO INSTALL CNC BENDER to A NEW COMPUTER
Follow these steps to setup CNC Bender on your new computer.
STEP 1 Close |
Close CNC Bender software on the operator station that you want to duplicate. |
STEP 2 Close |
Plug a USB FLASH DRIVE[1] into the operator station. (You will need a FLASH DRIVE with about 100 Megabytes of free memory.) </tr> </table>
SOUND SYSTEMAuditory sound messages are an important part of knowing the state of the bender control. I recommend that you be sure to use a computer with a sound system for operating CNC Bender sofware. --Mcone 13:07, 5 March 2007 (EST) |