FIF Translator Version 4 - September, 2007

From ATTWiki
Revision as of 03:37, 14 September 2007 by Mcone (Talk | contribs)

Jump to: navigation, search

Contents


Enhancements Information

  • Now ALL data found in an FIF file is converted to the Supravision format.
  • Distance data can be automatically converted to the other unit (Millimeters to Inches, or Inches to Millimeters).
  • Improved error handling.
  • This version retains both the XYZ and YBC data intact. There is no forced conversion in one direction or another between the two data types.


Data Included In Conversion

VELOCITY DATA



NEW Conversion of YBC axes speeds: 1 - 8

NEW FUNCTION DATA



  • Y Function - Bits 12345678
  • B Function - Bits 12345678
  • C Function - Bits 12345678


  • Y, B, C axes Stop Bits
  • C axis Last Bit

NEW PROCESS DATA



  • Default Radius
  • End A Diameter
  • End B Diameter

NEW TOOL DATA



Handles Up to 9 Radius Levels for:

  • Radius
  • Fixed Springback
  • Proportional Springback
  • Clamp Length
  • Clearance Feed
  • Clearance Angle

NEW MACHINE DATA from EL Setup Data



  • Ymin
  • Interference Zone 1
  • Interference Zone 2
  • Load Position
  • Load Offset
  • Y Position Tolerance
  • Pressure Die Open Code
  • Boost Delay

NEW MACHINE DATA from EL Extended Setup Data



  • Any number of EXTENDED setup values are automatically converted
  • Older benders (like Velog, EL-2000, and Premier) contain 40 extended setup values
  • Newer benders can contain more
  • FIF Translator takes in up to 99 extended values for conversion.


Automatic Conversion of Units

The following values can be automatically converted to Inches or Millimeters during conversion: