Difference between revisions of "D of Bend"

From ATTWiki
Jump to: navigation, search
(Examples)
(Notes)
 
(2 intermediate revisions by one user not shown)
Line 33: Line 33:
 
*D of bend = 0.75 is very difficult and much more expensive.
 
*D of bend = 0.75 is very difficult and much more expensive.
  
D of bend values at 1 and below are possible - but are rare and require special benders that can press material into the bender's dies.  (Most call this "carriage boost".)
+
===Notes===
 
+
*D of bend values at 1 and below are possible - but are rare and require special benders that can press material into the bender's dies.  (Most call this "carriage boost".)
<br><br>
+
*Other variables, like wall factor, impact what is difficult.  Wall factor = OD / Wall Thickness
Note: Other variables, like wall factor, impact what is difficult.  Wall factor = OD / Wall Thickness
+
  
 
==Example Models==
 
==Example Models==

Latest revision as of 15:49, 2 January 2020

Contents

What is D of bend?

Tube fabricators sometimes indicate the centerline radius using D of bend.

We say it by speaking three words: "D of bend".

Some tube fabricators also say "D factor" to mean the same thing.

It is a ratio calculated like this: D of bend = Centerline Radius / OD



How Is It Used?

FOR FABRICATORS

  • The D of bend value helps fabricators know if the radius is tight or large compared to the OD.
  • It serves as a general guide for how difficult it will be to create a quality bend.
  • It helps fabricators know what kind of tooling will be necessary to achieve the bend. It is useful, therefore, in building quotations for customers.
  • It is common for fabricators to share the lower limit of their D of bend capabilities with customers.

FOR DESIGNERS

  • It is helpful to designers as a limit for what is practical in choosing radii.



Example Values

In most applications, a lower D of bend valued radii is less complex and therefore less expensive.

  • D of bend = 2.00 or greater is generally considered not difficult.
  • D of bend = 1.50 is moderately difficult.
  • D of bend = 1.00 is difficult.
  • D of bend = 0.75 is very difficult and much more expensive.

Notes

  • D of bend values at 1 and below are possible - but are rare and require special benders that can press material into the bender's dies. (Most call this "carriage boost".)
  • Other variables, like wall factor, impact what is difficult. Wall factor = OD / Wall Thickness

Example Models

DofBend001.png DofBend002.png DofBend003.png DofBend004.png



Other Pages