DOCS2Addison Benderlink

From ATTWiki
Revision as of 03:51, 30 July 2010 by Mcone (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Docs2addison logo.jpg

DOCS2Addison Benderlink is software is designed to allow the AddisonMckee to communicate with the DOCS-based measuring center.

DOCS2Addison Run Screen
Addison databend.jpg Romer infinite.jpg


SETUP Screen

This is where all setup occurs in Benderlink. Up to 100 benders can be programmed and 'remembered in this Benderlink.

Docs2addison mainscreen setup.jpg

RUN Screen

This is the screen where Benderlinking occurs. Choose the bender number in the Setup screen, then switch to RUN.

Benderlink has two modes for AddisonMckee: NEW and CORRECTION. The two buttons on this screen let you choose one of the two modes. NEW is for sending new data to establish the part the first time. CORRECTION is for sending correction data to the bender. (AddisonMckee makes a distinction between the two.)

Docs2addison mainscreen run.jpg

Other Pages