Difference between revisions of "DCP - Diameter Cut Planes"

From ATTWiki
Jump to: navigation, search
(How DCP Works)
(Scanner Orientation Matters in DCP)
Line 34: Line 34:
 
=====Scanner Orientation Matters in DCP=====
 
=====Scanner Orientation Matters in DCP=====
 
The key is to remember that the scanner orientation determines which straight the DCP encounters first.<br><br>
 
The key is to remember that the scanner orientation determines which straight the DCP encounters first.<br><br>
 +
 +
See this same idea illustrated in the serpentine part:<br>
 +
[[image:vtube-laser_v2.6_diameter_cut_plane_grapic_002.png|500px]]<br><br>
 +
 +
DCP Selection Rule: '''The straight is selected based on the orientation of the Diameter Cut Plane relative to the straight.'''

Revision as of 23:41, 18 July 2016

  • VTube-LASER Version: 2.6
  • Date Released: July 15, 2016

VTube-LASER Diameter Cut Planes or the "DCP" feature in VTube-LASER, solves a scanning issue where multiple objects are in the view of the laser scanner at one time - but you must scan only one straight.

In previous versions, the only easy solution was to switch to using the ball probe in those sections where many objects were close to the tube straight being measured.

Contents

Measure Across Several Diameters - VTube will find the correct straight

However, this new feature lets you scan across several diameters or objects of any kind - and still AUTOMATICALLY scan in the single diameter you intend to measure.

The effect on the operator is to reduce stress and increase measuring speed drastically. See this image to understand the basic idea of the DCP feature and how it sorts detects the single diameter you intend to measure:

Vtube-laser v2.6 diameter cut plane grapic 002.png

Wirebending Applications

The feature was developed to solve a need when measuring wire bent parts. The orange part shown below is a sample test piece that is formed from 0.2 inch diameter wire. This is a small part that can sit on a tablet (see the black tablet for scale). When measuring this part the FARO scanner stripe often crosses four straights at the same time.

Vtube-laser v2.6 orange cardholder wirebend.png

Illustration of the Issue for Small Parts

Imagine the HD (blue) laser stripe measuring one of these four straights. In order to measure one, it is very hard to orient the beam in a way that scans only one straight. See this image to show the easiest way to measure straights 1, 3, 9 and 12:
Vtube-laser v2.6 orange cardholder wirebend pointers to 4diameter.png

In previous versions of VTube-LASER, this was not possible because the data from the four straights would have averaged into one large diameter, or, more likely, VTube would return an error during centerline calculation.

However, the DCP feature solves this issue by givng the operator a way to cross all four straights by following some simple rules that allow VTube to sort out and select the one straight that you intend to measure.

How DCP Works

These two slides illustrate how the DCP feature works:

Vtube-laser v2.6 cutplane slide1.png

Vtube-laser v2.6 cutplane slide2.png




Scanner Orientation Matters in DCP

The key is to remember that the scanner orientation determines which straight the DCP encounters first.

See this same idea illustrated in the serpentine part:
Vtube-laser v2.6 diameter cut plane grapic 002.png

DCP Selection Rule: The straight is selected based on the orientation of the Diameter Cut Plane relative to the straight.