Difference between revisions of "Configuring Machine Lube Settings"
(→Machine Lube Duration) |
(→Lube Machine At Bend Count) |
||
| Line 35: | Line 35: | ||
* Read how to set the [[Machine Lube Duration]] | * Read how to set the [[Machine Lube Duration]] | ||
| − | ==Lube Machine At Bend Count== | + | ====Value 2: "Lube Machine At Bend Count"==== |
* Read how to set the [[Lube Machine At Bend Count]] | * Read how to set the [[Lube Machine At Bend Count]] | ||
Revision as of 20:33, 28 January 2009
Contents |
CNCProcessor.cfg File
The CNC Processor configuration file contains the values necessary to adjust the machine lube settings.
Where to find it in CNC Bender
The configuration is displayed in an editor in the Low Level menu, CNC Processor CFG tab.
If you edit the values in this editor, be sure to keep the equals signs in the setup, and be careful to enter valid values. For example, for duration values, enter only whole numbers (no text).
Then save the data to disk in order to store the changes made.
Where to find it on the Hard Disk
The file is available in the c:\cnc\config folder in the file "CNCProcessor.cfg". A text editor can be used to change the file. Only change the file this way when CNC Bender is closed.
"Machine Lube" Section
The settings in this file are separated by sections with section names in square brackets. This is an example:
[Machine Lube] Machine Lube Duration=5000 Lube Machine At Bend Count=100 Pulse Machine Lube Pump=1 Watch For Machine Lube Complete Input=0
The four values above control the machine lube features in CNC Bender.
Value: "Machine Lube Duration"
- Read how to set the Machine Lube Duration
Value 2: "Lube Machine At Bend Count"
- Read how to set the Lube Machine At Bend Count
Pulse Machine Lube Pump
- Read how to set the Pulse Machine Lube Pump
Watch For Machine Lube Complete Input
- Read how to set the Watch For Machine Lube Complete Input
Other Pages
Back to
