Difference between revisions of "Change the default linear units in VTube"
From ATTWiki
(→25px Steps to changing the default linear units) |
|||
| Line 8: | Line 8: | ||
</td> | </td> | ||
<td width=300> | <td width=300> | ||
| − | [[image:Vtube- | + | [[image:Vtube-step_1_651.jpg|300px]]<br> |
[[image:vtube-laser_screen_1_54.jpg|300px]] | [[image:vtube-laser_screen_1_54.jpg|300px]] | ||
</td> | </td> | ||
Revision as of 14:22, 25 May 2022
|
|
|
Steps to changing the default linear units
| Use the toolbar buttons to clear VTube and press the Linear Units button until the correct units are active. |
|
| Press the System Options button. |
|
| Press the Project Setup tab, and then press the Set Project Default State button. |
|
|
Exit the System Options menu. VTube will now clear to the new linear unit. |
Other Pages
- Back to the VTube-STEP page
- Back to the VTube-LASER page
