CRIPPA

From ATTWiki
Revision as of 03:29, 7 November 2016 by Mcone (Talk | contribs)

Jump to: navigation, search


CRIPPA benders are built in Italy and marketed worldwide. Customers report that they like these benders very much. They are often all electric with all actuators servo-controlled.

Crippa bender.jpg

Crippa banner.jpg

Contents

CRIPPA UII Control software

The CRIPPA Windows software allows for complete programming of bender setup.

Crippa uii screen.jpg



VTube-LASER Support for Crippa Bender Setup and Corrections

VTube-LASER communicates with the CRIPPA UII software using the Supravision Network protocol.

Communications are fully bidirectional - you can send and recall data.

It is possible to send new part data to the Crippa, and to correct existing parts easily with the Crippa communications.

(Crippa added this capability in late 2014.)

Vtube-laser v2.2 crippa.png




VTube-STEP Support for CRIPPA Bender SPF Files

VTube-STEP can export Crippa export capability allows for easy export to Crippa UII software. The format is a text file that is compatible with most Crippa benders that were released in early 2012 and on.

Vtube step 1.77.4 crippa export.jpg


VTS2 SplashScreen.png


VTube-STEP and VTube-LASER Support for older CRIPPA Benders without Supravision Network Support

For CRIPPA benders that do not allow for Supravision Network protocol connections, VTube can also load and modify CRIPPA MPF file format. (VTube version v2.7)


VTS2 SplashScreen.png

Contact Information

CRIPPA USA Distributor

Chris Harrison
Tube Process Technology LLC
4343 SKUSA DR
BRIGHTON, MI 48116

Phone (810) 599-1972
E-Mail: [email protected]

Other Pages