Difference between revisions of "CNC Bender v15.10.1"

From ATTWiki
Jump to: navigation, search
(25pxFIX: BOOLEAN Parameter in Processlist)
(25pxENHANCED: FASTER GALIL AXIS ENABLE)
Line 16: Line 16:
  
 
==[[image:Check.jpg|25px]]ENHANCED: FASTER GALIL AXIS ENABLE==
 
==[[image:Check.jpg|25px]]ENHANCED: FASTER GALIL AXIS ENABLE==
 
<table width=1000>
 
<tr valign=top>
 
<td width=300>
 
 
Galil axis enables could take up to a second per axis on slower controls. This has been changed so that all axes are enabled simultaneously for a much faster enable.
 
Galil axis enables could take up to a second per axis on slower controls. This has been changed so that all axes are enabled simultaneously for a much faster enable.
</td>
 
<td width=600>
 
</td>
 
</tr>
 
</table>
 
  
 
==[[image:Check.jpg|25px]]ENHANCED: FASTER GALIL AXIS DISABLE==
 
==[[image:Check.jpg|25px]]ENHANCED: FASTER GALIL AXIS DISABLE==

Revision as of 19:02, 12 February 2018

v15.10.1 - February 9, 2018

Cncbender v15 logo.png


Check.jpgENHANCED: FASTER GALIL AXIS ENABLE

Galil axis enables could take up to a second per axis on slower controls. This has been changed so that all axes are enabled simultaneously for a much faster enable.

Check.jpgENHANCED: FASTER GALIL AXIS DISABLE

Galil axis disables were called to invididually taking too much time. This has been changed so that all axes are disable simultaneously.

Check.jpgFIX: QUICK GALIL DISABLE THEN RE-ENABLE

The Galil would shutdown if the operator disabled axes then enabled them very quickly. This has been resolved by puttina 1.5 second delay before the axis disable is allowed. If the operator presses Cycle Start within that time period, then the disable command is skipped.

Check.jpgFIX: BENDERLINK TRANSMISSION of ONE BEND PART

CNC Bender would not transmit one bend parts in Supravision. This has been fixed.

Check.jpgFIX: BOOLEAN Parameter in Processlist

Using boolean Dynamic Option parameters (to see if an option is on or off), would shutdown CNC Processor. This has been resolved.

Check.jpgFIX: CUSTOM UNLOAD

Custom Unload no longer automatically calls to bend arm return to home.

Other Pages