CNC Bender v10-20070914

From ATTWiki
Revision as of 23:38, 20 September 2007 by Mcone (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search
CNC Bender User Interface for ProControl

Cncbender logo.jpg

Contents



IMPROVED: Improved Auto Build during AUTO MODE

Explanation

Cncbender autobuild.jpg
    • There was a possibility that the process list builder would attempt to build a process list even though CNC Bender had not switched to MANUAL mode.
    • This situation would cause errors or lockups.

Solution To Issue

    This version patiently waits for CNC Processor to switch to MANUAL mode before attempting to build the process list.



IMPROVED: MASTER Folder Protected from Non-Password Part Load or Save

Explanation

    • CNC Bender would allow a user to switch from the PARTS folder to the MASTER folder while loading parts, thus bypassing the password entry box.


Solution To Issue

    This version will no longer allow access to the MASTER folder from the PARTS LOAD or SAVE dialogs.

How to UPGRADE

If your operator station contains one of the versions listed below, then they can be upgraded through simple self-installation:


Please contact Advanced Tubular Technologies for upgrade information.