Difference between revisions of "CNC Bender v10-20070914"

From ATTWiki
Jump to: navigation, search
(IMPROVED: MASTER Folder Protected from Part Load)
Line 47: Line 47:
  
 
* CNC Bender would allow a user to switch from the PARTS folder to the MASTER folder while loading parts, thus bypassing the password entry box.
 
* CNC Bender would allow a user to switch from the PARTS folder to the MASTER folder while loading parts, thus bypassing the password entry box.
 +
 +
</ul>
 +
 +
 +
===Solution To Issue===
 +
 +
<ul>
 +
 +
This version will no longer allow access to the MASTER folder from the PARTS LOAD or SAVE dialogs.
 +
 +
<br><br>
 +
 +
  
 
</ul>
 
</ul>

Revision as of 22:59, 20 September 2007

CNC Bender User Interface for ProControl


Contents



IMPROVED: Improved Auto Build during AUTO MODE

Explanation

Cncbender autobuild.jpg
    • There was a possibility that the process list builder would attempt to build a process list even though CNC Bender had not switched to MANUAL mode.
    • This situation would cause errors or lockups.

Solution To Issue

    This version carefully and patiently waits for CNC Processor to switch to MANUAL mode before attempting to build the process list.




IMPROVED: MASTER Folder Protected from Part Load

Explanation

    • CNC Bender would allow a user to switch from the PARTS folder to the MASTER folder while loading parts, thus bypassing the password entry box.


Solution To Issue

    This version will no longer allow access to the MASTER folder from the PARTS LOAD or SAVE dialogs.

How to UPGRADE

If your operator station contains one of the versions listed below, then they can be upgraded through simple self-installation:


Please contact Advanced Tubular Technologies for upgrade information.