CNC Bender v10-20070705

From ATTWiki
Revision as of 20:42, 6 July 2007 by Mcone (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search
CNC Bender User Interface for ProControl


Contents


REVISION Information

10-20070705, July 5, 2007


NEW: Low Level Option - Don't Warn if Skip Run Buttons

Experienced operators asked us to allow CNC Bender to warn when the SKIP RUN BUTTONS feature is enabled in the Pre-Bend Options page. This issue was addressed by inserting an Immediate Message warning and a Cycle Hold into the processlist if this condition exists.

If the option is ENABLED, then there is no warning if the Skip Run Buttons feature is enabled.


ENHANCED: Support for All Eight Programmable Limit Switches

CNC Bender can now support all eight Programmable Limit Switches for any motion-controlled axis.




BENDER LIST: Which Controls Was This Installed On?

  • SMT 19150 - Right Hand Electric MiiC Bender - Dual Radius Carriage Shifter
  • SMT 19152 - Right Hand Electric Eagle Bender - Single Radius
  • SMT 20118 - Left Hand Eagle Bender - Dual Radius Head Shifter