Difference between revisions of "CNC Bender v10-20070705"

From ATTWiki
Jump to: navigation, search
(BENDER LIST: Which Controls Was This Installed On?)
(Which Benders Was This Version of CNC Bender Installed On?)
 
(One intermediate revision by one user not shown)
Line 30: Line 30:
 
<br>
 
<br>
  
=BENDER LIST: Which Benders Was This Version of CNC Bender Installed On?=
+
=Bender List=
  
 
*SMT 19150 - Right Hand Electric MiiC Bender - Dual Radius Carriage Shifter
 
*SMT 19150 - Right Hand Electric MiiC Bender - Dual Radius Carriage Shifter
 
*SMT 19152 - Right Hand Electric Eagle Bender - Single Radius
 
*SMT 19152 - Right Hand Electric Eagle Bender - Single Radius
 
*SMT 20118 - Left Hand Eagle Bender - Dual Radius Head Shifter
 
*SMT 20118 - Left Hand Eagle Bender - Dual Radius Head Shifter

Latest revision as of 20:48, 6 July 2007

CNC Bender User Interface for ProControl


Contents


REVISION Information

10-20070705, July 5, 2007


NEW: Low Level Option - Don't Warn if Skip Run Buttons

Experienced operators asked us to allow CNC Bender to warn when the SKIP RUN BUTTONS feature is enabled in the Pre-Bend Options page. This issue was addressed by inserting an Immediate Message warning and a Cycle Hold into the processlist if this condition exists.

If the option is ENABLED, then there is no warning if the Skip Run Buttons feature is enabled.


ENHANCED: Support for All Eight Programmable Limit Switches

CNC Bender can now support all eight Programmable Limit Switches for any motion-controlled axis.




Bender List

  • SMT 19150 - Right Hand Electric MiiC Bender - Dual Radius Carriage Shifter
  • SMT 19152 - Right Hand Electric Eagle Bender - Single Radius
  • SMT 20118 - Left Hand Eagle Bender - Dual Radius Head Shifter