Difference between revisions of "CNC Bender v10-20070705"
From ATTWiki
(→BENDER LIST: Which Controls Was This Installed On?) |
|||
| Line 30: | Line 30: | ||
<br> | <br> | ||
| − | =BENDER LIST: Which | + | =BENDER LIST: Which Benders Was This Version of CNC Bender Installed On?= |
*SMT 19150 - Right Hand Electric MiiC Bender - Dual Radius Carriage Shifter | *SMT 19150 - Right Hand Electric MiiC Bender - Dual Radius Carriage Shifter | ||
*SMT 19152 - Right Hand Electric Eagle Bender - Single Radius | *SMT 19152 - Right Hand Electric Eagle Bender - Single Radius | ||
*SMT 20118 - Left Hand Eagle Bender - Dual Radius Head Shifter | *SMT 20118 - Left Hand Eagle Bender - Dual Radius Head Shifter | ||
Revision as of 20:43, 6 July 2007
Contents |
REVISION Information
10-20070705, July 5, 2007
NEW: Low Level Option - Don't Warn if Skip Run Buttons
Experienced operators asked us to allow CNC Bender to warn when the SKIP RUN BUTTONS feature is enabled in the Pre-Bend Options page. This issue was addressed by inserting an Immediate Message warning and a Cycle Hold into the processlist if this condition exists.
If the option is ENABLED, then there is no warning if the Skip Run Buttons feature is enabled.
ENHANCED: Support for All Eight Programmable Limit Switches
CNC Bender can now support all eight Programmable Limit Switches for any motion-controlled axis.
BENDER LIST: Which Benders Was This Version of CNC Bender Installed On?
- SMT 19150 - Right Hand Electric MiiC Bender - Dual Radius Carriage Shifter
- SMT 19152 - Right Hand Electric Eagle Bender - Single Radius
- SMT 20118 - Left Hand Eagle Bender - Dual Radius Head Shifter
