CNC Bender v10-20070702

From ATTWiki
Revision as of 23:54, 20 September 2007 by Mcone (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search
CNC Bender User Interface for ProControl

Cncbender logo.jpg

Contents


REVISION Information

10-20070702, July 2, 2007


NEW: LiteControl User Interface Update

The LiteControl now features the same updated GUI as the ProControl. It also requires the the higher screen resolution of 1024 x 768. (SMT and ATT are shifting away from the older 800 x 600 screen resolution - which is too low for the new software.)

CNC Bender User Interface for LiteControl


NEW: Splash / Version Screen Shows License Type

Cncbender v10-20070702 splash procontrol full.jpg Cncbender v10-20070702 splash procontrol offline.jpg


CNC Bender can use one of four license models:

During startup or display of the version screen, the license type is displayed. For example, this shows the OFFLINE license type is running:




NEW Option: CYCLE HOLD after POST-BEND JOG

Cncbender bendoptions cyclehold after postbendjog.jpg
    The BEND OPTION cells contain a new Cycle Hold option that allows for tool clearance immediately after a Post-Bend jog.

    If ON, this option will insert a cycle hold in bend program. The cycle hold is inserted immediately after the post bend jog that follows any bend. Example: To place the bender in Cycle Hold after the first bend’s post bend jog, enable this option in the first bend option.




CHANGE: Hardware Key Handling

There are new rules requiring hardware key setup for CNC Bender:

REQUIRED PROGRAM ID



Hardware Keys used for CNC Bender now require an appropriate program ID in both the time-limited and the permanent hardware key.

A program ID is a license number that resides in the Hardware Keys that indicate which of our software packages are allowed to run on the computer system.

This is now true of both TIME and PERMANENT keys.

LiteCONTROL -

PERMANENT KEYS



LiteControl licenses are now linked to a single specific hardware key. The setup of every PERMANENT KEYED LiteControl configuration file must be performed by Advanced Tubular before CNC Bender LiteControl will run.

Cncbender v10-20070702 splash litecontrol full.jpg


ProCONTROL -

PERMANENT KEYS



ProControl licenses are NOT linked to a specific hardware key, but the hardware key must contain a general ProControl license.

TIME KEYS



Neither LiteControl or ProControl licenses are linked to to a single hardware key. However, the hardware key must contain a setup for at least one of the four license types (see the previous topic).