Difference between revisions of "CNC Bender v10-20070702"

From ATTWiki
Jump to: navigation, search
(ENHANCED NEW Option: CYCLE HOLD after POST-BEND JOG)
(NEW: Splash / Version Screen Shows License Type)
Line 28: Line 28:
 
CNC Bender can use one of four license models:
 
CNC Bender can use one of four license models:
  
* ProControl Full<br>
+
* [[ProControl]] Full<br>
* ProControl Offline<br>
+
* [[ProControl]] Offline<br>
* LiteControl Full<br>
+
* [[LiteControl]] Full<br>
* LiteControl Offline<br>
+
* [[LiteControl]] Offline<br>
  
 
During startup or display of the version screen, the license type is displayed.  For example, this shows the OFFLINE license type is running:
 
During startup or display of the version screen, the license type is displayed.  For example, this shows the OFFLINE license type is running:

Revision as of 22:05, 2 July 2007

CNC Bender User Interface for ProControl
CNC Bender User Interface for LiteControl


Contents


REVISION Information

10-20070707, July 2, 2007


NEW: LiteControl GUI Update

The LiteControl now features the same updated GUI as the ProControl. It also requires the the higher screen resolution of 1024 x 768. (The older 800 x 600 is too low for the new software.)




NEW: Splash / Version Screen Shows License Type

Cncbender v10-20070702 splash procontrol full.jpg Cncbender v10-20070702 splash procontrol offline.jpg


CNC Bender can use one of four license models:

During startup or display of the version screen, the license type is displayed. For example, this shows the OFFLINE license type is running:




ENHANCED: Hardware Key Handling

There are new rules requiring hardware key setup for CNC Bender:

REQUIRED PROGRAM ID



Hardware keys used for CNC Bender now require an appropriate program ID in both the time-limited and the permanent hardware key.

This is now true of both TIME and PERMANENT keys.

LiteCONTROL -

PERMANENT KEYS



LiteControl licenses are now linked to a single specific hardware key. The setup of every PERMANENT KEYED LiteControl configuration file must be performed by Advanced Tubular before CNC Bender LiteControl will run.

Cncbender v10-20070702 splash litecontrol full.jpg


ProCONTROL -

PERMANENT KEYS



ProControl licenses are NOT linked to a specific hardware key, but the hardware key must contain a general ProControl license.

TIME KEYS



Neither LiteControl or ProControl licenses are linked to to a single hardware key. However, the hardware key must contain a setup for at least one of the four license types (see the previous topic).




NEW Option: CYCLE HOLD after POST-BEND JOG

The BEND OPTION cells contain a new Cycle Hold option that allows for tool clearance immediately after a Post-Bend jog.