Difference between revisions of "CNC Bender v10-20070702"

From ATTWiki
Jump to: navigation, search
(ENHANCED: Hardware Key Handling)
(ENHANCED: Hardware Key Handling)
Line 67: Line 67:
 
LiteControl licenses are now linked to a single specific hardware key.  The setup of every PERMANENT KEYED LiteControl configuration file must be performed by Advanced Tubular before CNC Bender LiteControl will run.
 
LiteControl licenses are now linked to a single specific hardware key.  The setup of every PERMANENT KEYED LiteControl configuration file must be performed by Advanced Tubular before CNC Bender LiteControl will run.
  
[[Image:cncbender_v10-20070702_splash_litecontrol_full.jpg|250px]]
+
[[Image:cncbender_v10-20070702_splash_litecontrol_full.jpg|300px]]
  
  

Revision as of 20:40, 2 July 2007

CNC Bender User Interface for ProControl


Contents


REVISION Information

10-20070707, July 2, 2007


NEW: LiteControl GUI Update

The LiteControl now features the same updated GUI as the ProControl. It also requires the the higher screen resolution of 1024 x 768. (The older 800 x 600 is too low for the new software.)




NEW: Splash / Version Screen Shows License Type

Cncbender v10-20070702 splash procontrol full.jpg Cncbender v10-20070702 splash procontrol offline.jpg


CNC Bender can use one of four license models:

  • ProControl Full
  • ProControl Offline
  • LiteControl Full
  • LiteControl Offline

During startup or display of the version screen, the license type is displayed. For example, this shows the OFFLINE license type is running:




ENHANCED: Hardware Key Handling

There are new rules requiring hardware key setup for CNC Bender:

REQUIRED PROGRAM ID



Hardware keys used for CNC Bender now require an appropriate program ID in both the time-limited and the permanent hardware key.

This is now true of both TIME and PERMANENT keys.

LiteCONTROL -

PERMANENT KEYS



LiteControl licenses are now linked to a single specific hardware key. The setup of every PERMANENT KEYED LiteControl configuration file must be performed by Advanced Tubular before CNC Bender LiteControl will run.

Cncbender v10-20070702 splash litecontrol full.jpg


ProCONTROL -

PERMANENT KEYS



ProControl licenses are NOT linked to a specific hardware key, but the hardware key must contain a general ProControl license.

TIME KEYS



Neither LiteControl or ProControl licenses are linked to to a single hardware key. However, the hardware key must contain a setup for at least one of the four license types (see the previous topic).

ENHANCED: NEW Option: CYCLE HOLD after POST-BEND JOG

The BEND OPTION cells contain a new CYCLE HOLD option that allows for tool clearance immediately after a Post-Bend jog.