Difference between revisions of "CNC Bender Robot Integration"

From ATTWiki
Jump to: navigation, search
 
(4 intermediate revisions by one user not shown)
Line 9: Line 9:
  
 
Read more about the SMT/ATT standard here: [[Robot Integration Standard 1]]
 
Read more about the SMT/ATT standard here: [[Robot Integration Standard 1]]
 
 
==Logic Flow for Robot Type 1 Integration==
 
 
You can view sample LOAD and UNLOAD logic here for our standard robot (type 1) integration.
 
  
 
<br>
 
<br>
 +
See the video tutorial on [[Switching Robot Standard 1 ON]]
  
<table cellpadding="15" width = 450>
+
=== Other Pages ===
<tr valign="top">
+
<td bgcolor="#abbad1" width = 200>
+
[[image:Cncbender_robot1_unloadlogic_thumb.jpg|200px]]
+
</td>
+
<td bgcolor="#e3e4f5">
+
[http://www.advancedtubular.com/cncbender/StandardCNCBenderRobotUnloadLogic.pdf View Unload Logic PDF document]
+
</td>
+
</tr>
+
 
+
<tr valign="top">
+
<td bgcolor="#abbad1" width = 200>
+
[[image:Cncbender_robot1_loadlogic_thumb.jpg|200px]]
+
</td>
+
<td bgcolor="#e3e4f5">
+
[http://www.advancedtubular.com/cncbender/StandardCNCBenderRobotLoadLogic.pdf View Load Logic PDF document]
+
</td>
+
</tr>
+
 
+
</table>
+
 
+
==Command Setup for Robot Type 1==
+
 
+
This chart shows an example of of the the command set that is used by CNC Bender to integrate to standard robots.<br><br>
+
<i>
+
(Note that the input/output point assignment is for bender 16188.  The assignment may vary slightly between benders.  However, the COMDEF and CIO names will remaine the same):
+
</i>
+
<br><br>
+
[[image:Cncbender_commandsetup_robot_type1.jpg]]
+
<br><br>
+
The '''robot_check_fault''' secondary process is told to start just before the last bend begins, then told to disable at the start of the next cycle (next part).  The process looks something like this:
+
  
<pre>
+
*Back to [[CNC Bender]] page
[if] and, BeyondPowerOnTime=2000, input=Input_RobotFault_End
+
  [immediate_message]IMMEDIATE SHUTDOWN - Robot Fault - digital_input_205:
+
  OutputControlOff
+
  [SECONDARY_PROCLIST] robot_check_fault, disable
+
[end]
+
</pre>
+

Latest revision as of 20:56, 26 September 2008

Industrial robot.jpg

Cncbender logo.jpg

CNC Bender can integrate to robots for both loading and unloading.

Formalization of Robot Specification

As of CNC Bender v11-20080725, we have standardized a robot specification that is useful for both LOAD and UNLOAD.

Read more about the SMT/ATT standard here: Robot Integration Standard 1


See the video tutorial on Switching Robot Standard 1 ON

Other Pages