Building Tube Assemblies in SOLIDWORKS

From ATTWiki
Revision as of 20:34, 2 June 2016 by Mcone (Talk | contribs)

Jump to: navigation, search

Vtube-step logo 1.96.png Vtube-laser logo 1.96.png

Vtl screen hd scanner without logo.png


Vtube-laser v2.5 header to measure.png

VTube-LASER can reverse engineer tube and then build that tube in SOLIDWORKS as a fully-constrained 3D parametric model. This page describes the basic steps to create an assembly from a part using VTube-LASER and SOLIDWORKS.


STEP 1: Measure One of the Parts in VTube-LASER

Measure the first pipe and create a measured tube shape.

Vtube-laser v2.5 measure header pipe.png

STEP 2: Build the Part in SOLIDWORKS

Use the File tab in Measure Tube Data to send the measured part to SOLIDWORKS.

Vtube-laser v2.5 build solidworks.png


STEP 3: Save the SOLIDWORKS Part File

Save the part to a unique SOLIDWORKS part file on the disk.

Vtube-laser v2.5 solidworks part.png


STEP 4: Repeat Steps 1 through 3 for all the parts

Be careful to not move the assembly. Repeat the first three steps for each tube.

STEP 5: Start a New Assembly

Start a new assembly. These steps show how to insert four parts from the SOLIDWORKS part files.

Vtube-laser v2.5 solidworks new assembly.png


STEP 6: Cancel the New Assembly Feature

In order to insert the tubes in the proper location, we need to establish the common origin in a plane. So press Cancel new assembly first.

Vtube-laser v2.5 solidworks cancel new assembly.png


STEP 7: Create a Reference Plane at the Origin

Insert a new plane, then press Finish. It is not necessary to change the location of the plane - since it is already centered around the world origin.

Vtube-laser v2.5 solidworks insert a plane.png


STEP 8: Press Insert Components in Assemblies

Press Insert Components.

Vtube-laser v2.5 solidworks insert a component.png

STEP 9: Select Multiple SOLIDWORKS Files

Use Ctrl + or Shift + to select multiple parts to include in the assembly.

Vtube-laser v2.5 solidworks select multiple swparts to import.png


STEP 10: Select the Origin

Point to the middle of the plane and click. Do this for each part until all the parts are inserted at the origin.

Vtube-laser v2.5 solidworks insert part.png

STEP 11: Repeat STEP 10 for Each Part

Click the origin at the center of the plane for each part.

Vtube-laser v2.5 solidworks insert part repeat.png

STEP 12: Exit the Sketch

Exit the sketch after all the parts are inserted.

Vtube-laser v2.5 solidworks insert part exit sketch.png

Read More About Tube Elongation



Other Pages