Difference between revisions of "Benderlink for SolidWorks NLM Installation"

From ATTWiki
Jump to: navigation, search
Line 7: Line 7:
 
<tr>
 
<tr>
 
<td>Step 1.</td>
 
<td>Step 1.</td>
<td width=300>Plug the hardware key that was shipped to you with the Dell computer into the Server.</td>
+
<td bgcolor="#CCFFFF" width=300>Plug the hardware key that was shipped to you with the Dell computer into the Server.</td>
 
</tr>
 
</tr>
 
</table>
 
</table>

Revision as of 20:30, 5 March 2008

Blinkswlogo.jpg

Solidworkslogo.png

This page addresses how to setup the Network License Manager for use with Benderlink for SolidWorks.

Step 1. Plug the hardware key that was shipped to you with the Dell computer into the Server.


Step 2. Download and install the Network License Manager software on the server.

   You can download this software at:
   http://www.advancedtubular.com/customers/spectrum/setup_att_nlm.exe


Step 3. Once the software is downloaded an installed, run the program.

   Under the "Hardware Key Data" tab, verify that The "Key Type" is "memo" and that the "Key Serial Number" matches the "Licensed Key Serial Number".
   Next, check the "Licensed Applications" tab.  "Application Name" should say "Benderlink for Solidworks" and "Max Seats" is "1".


If for any reason something is out of place, please contact me and I'll see that it gets fixed!

Step 4. Download and install Benderlink for Solidworks on the client computer.

   You can download this software at:
   http://www.advancedtubular.com/customers/spectrum/setup_blinksw_1_7.exe


Step 5. Once installed you'll need to edit the configuration file that is located at:

   C:\Program Files\blinksw\config\blinksw.config
   Using Notepad is the easiest way to edit this file.  To do this, right-click on "blinksw.config" and choose "Open With", then choose "Notepad" from the Menu.
   Once you are editing the file, look for the line that says:
   "NLM IP Address=127.0.0.1"
   Change this address to the IP address of the server that the NLM software is installed on.
   Once you have done that, you can save the file and exit Notepad.


Step 6. Run Benderlink for Solidworks. The NLM Server software should report that a user is logged into Benderlink for Solidworks and that there are Zero seats of the software available.

If for any reason something is out of place, please contact me and I'll see that it gets fixed!


Regards, John Esralian Advanced Tubular Technologies (248) 674-2059