Benderlink for Pines

From ATTWiki
Revision as of 01:22, 1 May 2008 by Mcone (Talk | contribs)

Jump to: navigation, search
Light arrows.jpg

Blink pines logo.jpg


Contents

About

Benderlink for Pines is software that connects PINES TS-2000 controls with Eaton Leonard Vector Laservision measuring centers.

It essentially makes a TS-2000 control appear to be an Eaton Leonard PREMIER control to a Vector Laservision measuring center.

Blinkpines v2 mainscreen.jpg

TS-2000 Control to Vector 1 Laservision

Ts-2000.jpg The software installs directly on the operator station of the Pines TS-2000 controls. It is designed to interact directly with the control. The designer of the TS-2000 included a "Laservision" button that loads and calls to Benderlink for Pines.

The protocol used is the Velog/El-2000/Premier protocol - so the software is compatible with Eaton Leonard Vector Laservision out of the box.

EL Laservision Tube Data Center.jpg

Version 2.0 - Plug-And-Play Compatible with Vector Laservision

Version 2 is designed to communicate using the standard Eaton Leonard Velog, EL-2000, and Premier protocol. This protocol is available on every Eaton Leonard measuring center.


This version makes any PINES bender answer as a Velog, EL-2000, or Premier control.

Both STANDARD and EXTENDED protocols are handled. The Extended protocol is intended for multiple radius benders.

Blinkpines v2 mainscreen.jpg

Version 1.0 (Obsolete)

Version 1 of Benderlink for Pines communicated with Laservisions using the ATT protocol. The ATT protocol was a special protocol that required customers to purchase and install an upgrade to the Vector Laservision. Eaton Leonard referred to this as a "Competitive Bender Interface" because it was designed to grant competitors the right to use the measuring center through license charges.


This CBI kit was costly and time-consuming for the customer. Version 2 of our software addressed this issue.

Blinkpines v1 mainscreen.jpg


Screen Shot Date Released Link to Page New Features
Blinksw v2 sw180.jpg April 28, 2008 Benderlink for Pines 2.0
  • 100% Compatible with standard Eaton Leonard protocols
  • 100% Compatible with PINES TS-2000 control
  • New Updated User Interface
  • New Utilities for working with Benderlink Ethernet Modules - like Ping checking before opening a virtual COM port.


LASERVISION.jpg
PINES bender.jpg

Other Pages

Back to the Benderlink Page