Difference between revisions of "Benderlink for Pines"
From ATTWiki
(→Version 1.0 - ATT Protocol (Competitive Bender Interface)) |
(→Version 2.0) |
||
| Line 36: | Line 36: | ||
==Version 2.0== | ==Version 2.0== | ||
| − | Version 2 is designed to communicate using the standard Eaton Leonard Velog, EL-2000, and Premier protocol. This protocol is available on every Eaton Leonard measuring center. No upgrade is necessary. | + | {| border="0" cellpadding="5" cellspacing="0" align="none" width=600 |
| − | <br><br> | + | |- |
| − | [[image:Blinkpines_v2_mainscreen.jpg|200px]] | + | | Version 2 is designed to communicate using the standard Eaton Leonard Velog, EL-2000, and Premier protocol. This protocol is available on every Eaton Leonard measuring center. No upgrade is necessary.<br> |
| + | <br> | ||
| + | This CBI kit was costly and time-consuming for the customer. Version 2 of our software addressed this issue. | ||
| + | | [[image:Blinkpines_v2_mainscreen.jpg|200px]] | ||
| + | |} | ||
| + | |||
[[image:LASERVISION.jpg|right]] | [[image:LASERVISION.jpg|right]] | ||
[[image:PINES_bender.jpg|right]] | [[image:PINES_bender.jpg|right]] | ||
| − | |||
=Other Pages= | =Other Pages= | ||
Back to the [[Benderlink]] Page | Back to the [[Benderlink]] Page | ||
Revision as of 01:06, 1 May 2008
Contents |
About
| Benderlink for Pines is software that connects PINES TS-2000 controls with Eaton Leonard Vector Laservision measuring centers. | 
|
TS-2000 Control to Vector 1 Laservision
|
The software installs directly on the operator station of the Pines TS-2000 controls. It is designed to interact directly with the control. The designer of the TS-2000 included a "Laservision" button that loads and calls to Benderlink for Pines. The protocol used is the Velog/El-2000/Premier protocol - so the software is compatible with Eaton Leonard Vector Laservision out of the box. |
|
Versions
Version 1.0 - ATT Protocol (Competitive Bender Interface)
| Version 1 of Benderlink for Pines communicated with Laservisions using the ATT protocol. The ATT protocol was a special protocol that required customers to purchase and install an upgrade to the Vector Laservision. Eaton Leonard referred to this as a "Competitive Bender Interface" because it was designed to grant competitors the right to use the measuring center through license charges.
|
|
Version 2.0
| Version 2 is designed to communicate using the standard Eaton Leonard Velog, EL-2000, and Premier protocol. This protocol is available on every Eaton Leonard measuring center. No upgrade is necessary.
|
|
Other Pages
Back to the Benderlink Page
