Difference between revisions of "Benderlink for Pines"

From ATTWiki
Jump to: navigation, search
(TS-2000 Control to Vector 1 Laservision)
(TS-2000 Control to Vector 1 Laservision)
Line 14: Line 14:
  
  
{| border="0" cellpadding="5" cellspacing="0" align="none" width=600
+
{| border="0" cellpadding="5" cellspacing="0" align="none" width=700
 
|-
 
|-
 
| [[image:Ts-2000.jpg|100px]]
 
| [[image:Ts-2000.jpg|100px]]

Revision as of 01:00, 1 May 2008

Blink pines logo.jpg


Contents

About

Benderlink for Pines is software that connects PINES TS-2000 controls with Eaton Leonard Vector Laservision measuring centers. Blinkpines v2 mainscreen.jpg

TS-2000 Control to Vector 1 Laservision

Ts-2000.jpg The software installs directly on the operator station of the Pines TS-2000 controls. It is designed to interact directly with the control. The designer of the TS-2000 included a "Laservision" button that loads and calls to Benderlink for Pines.

The protocol used is the Velog/El-2000/Premier protocol - so the software is compatible with Eaton Leonard Vector Laservision out of the box.

EL Laservision Tube Data Center.jpg

Versions

Version 1.0

Version 1 of Benderlink for Pines communicated with Laservisions using the ATT protocol. The ATT protocol was a special protocol that required customers to purchase and install an upgrade to the Vector Laservision.

Blinkpines v1 mainscreen.jpg

Version 2.0

Version 2 is designed to communicate using the standard Eaton Leonard Velog, EL-2000, and Premier protocol. This protocol is available on every Eaton Leonard measuring center. No upgrade is necessary.

Blinkpines v2 mainscreen.jpg


LASERVISION.jpg
PINES bender.jpg