Difference between revisions of "Benderlink for KEINS"

Revision as of 21:56, 13 October 2008

This software is designed to communicate with Chiyoda and KEINS benders.

MAIN FEATURES

1 - It allows for intelligent bi-directional communications with measuring centers.

2 - It allows for offline programming.

3 - It allows customers to use a PC disk / network to store all Chiyoda / KEINS parts off the control. (Bypassing the floppy drive.)

LICENSE TYPES

There are four license types:

• FULL Level 1: Communicate and manage files for up to 99 benders.
  
  
• FULL Level 2: Communicate and manage files for up to 99 benders. PLUS Edit bender data in Windows
  
  
• FULL Level 3: Communicate and manage files for up to 99 benders. Edit bender data in Windows. PLUS enable CORRECTIONS LOOPS with measuring centers.
  
  

See the PDF data sheet section below for details. Each of these license levels allows you to custom-tailor your purchase with your application.

• OFFLINE: The Benderlink offline license allows engineers to program Benderlink from a location that are off-site or at a remote location. The only difference between the OFFLINE license and the FULL license is that the OFFLINE version of the software will not communicate with benders. Typically offline license is used to save the data files to a shared network location. The full version of Benderlink for CHIYODA that is connected to the bender can load the files created and saved with the offline version of Benderlink.

PDF DataSheets

REVISIONS