Benderlink Ethernet Module

This is a Benderlink wireless device module setup for connection to an Eaton Leonard bender

The Benderlink wireless device module is used with benders that use the RS-232 protocol for communications.

Why is it needed?

Some benders require the legacy RS-232 protocol for communications. The device allows RS-232 signals to be converted into either encyrpted WiFi or WIRED TCP/IP signals. This overcomes the distance limitations inherent to RS-232 (max of 50 feet). RJ-45 cables transferring ethernet, have a distance limitation of over 300 feet between switches. Wireless distance limitations vary with the characteristics of the plant setup. A typical max distance for wireless is 100 to 150 feet.

Which Benders Use It?

Currently the benders that we can support using this module are:

• Chiyoda
• Keins
• MiiC
• Eaton Leonard (The EL benders require this device and an embedded computer.)

Why Don't Other Benders Need This Module?

Other benders often use newer technology. For example, the Advanced Tubular CNC Bender software recognizes and uses the SVNET protocol, which is a network protocol that does not need serial ports.

--Mcone 17:32, 28 July 2006 (EDT)