Difference between revisions of "Benderlink Ethernet Module"
(→Which Benders Use It?) |
|||
Line 25: | Line 25: | ||
[[image:benderlink_ethernet_module_for_el.jpg|400px]] | [[image:benderlink_ethernet_module_for_el.jpg|400px]] | ||
+ | |||
+ | |||
+ | ==PDF DataSheets== | ||
+ | |||
+ | |||
+ | <table cellpadding="15" width = 650> | ||
+ | <tr valign="top"> | ||
+ | <td bgcolor="#abbad1" width = 200> | ||
+ | [[image:Blinkel_datasheet_page1.jpg|200px]] | ||
+ | </td> | ||
+ | <td bgcolor="#e3e4f5"> | ||
+ | Download a DataSheet for Benderlink Ethernet Module for Eaton Leonard | ||
+ | [http://www.advancedtubular.com/blink_el/benderlink_el_v4_datasheet.pdf] | ||
+ | </td> | ||
+ | </tr> | ||
+ | </table> | ||
+ | |||
===Why Don't Other Benders Need This Module?=== | ===Why Don't Other Benders Need This Module?=== |
Revision as of 04:04, 12 June 2007
Contents |
The Benderlink Ethernet Module is used with benders that use the RS-232 protocol for communications. The module also include a standard RJ-45 port for connection through standard LAN cable connection.
Why is it needed?
Some benders require the legacy RS-232 protocol for communications. The device allows RS-232 signals to be converted into either encyrpted WiFi or WIRED TCP/IP signals. This overcomes the distance limitations inherent to RS-232 (max of 50 feet). RJ-45 cables transferring ethernet, have a distance limitation of over 300 feet between switches. Wireless distance limitations vary with the characteristics of the plant setup. A typical max distance for wireless is 100 to 150 feet.
Which Benders Use It?
Currently the benders that we can support using this module are:
- Chiyoda
- Keins
- MiiC
- Eaton Leonard (This is the first and only device in the world that allows EL Velog, EL-2000, and EL-Premier computers to communicate wirelessly.) See Benderlink for Eaton Leonard
- Adaptive Motion Control Benders using the Eaton Leonard protocol
PDF DataSheets
Download a DataSheet for Benderlink Ethernet Module for Eaton Leonard [1] |
Why Don't Other Benders Need This Module?
Many benders now have network capability built-in to the control. For example, the Advanced Tubular CNC Bender software recognizes and uses the SVNET protocol, which is a network protocol that does not need serial ports.
--Mcone 17:32, 28 July 2006 (EDT)