Difference between revisions of "Benderlink Current Loop 4 Port - Measuring Center Side"
From ATTWiki
(→Measuring Center) |
|||
| Line 3: | Line 3: | ||
[[image:Currentloop_4port_ms_box2.jpg|400px]] | [[image:Currentloop_4port_ms_box2.jpg|400px]] | ||
<br><br> | <br><br> | ||
| − | == | + | ==How Its Used== |
| − | This module was placed near the Romer measuring center computer. | + | This module was placed near the [[Romer]] measuring center computer. |
==How it Connects== | ==How it Connects== | ||
Revision as of 15:20, 21 April 2008
This is a four port module that was designed for a measuring center application where the customer has four Eaton Leonard benders: a LightSpeed control, two Premier controls, and an EL-2000 controlled Eaton Leonard bender.
How Its Used
This module was placed near the Romer measuring center computer.
How it Connects
This box connects using:
- RJ-45 ports - Ethernet cable converted to serial using RJ-45 to DB9 converters
- The RJ-45 ports connect to a four-port Quatech PCI board (Model: QS-PCI-100) The serial cables run from the RJ-45 ports to the COM ports on the measuring center computer.
- Circular Military Connectors (female)
- The military connectors are connected to the Advanced Tubular current loop boards.
This is an image of the box installed under the work-bench with a Romer arm and computer system:
