VTube-LASER Training Agenda

Back to VTube-LASER

About the Training Agenda

Training agendas for VTube-LASER usually follow the pattern shown below. We often adjust the training depending on the customer's application needs.

Number of Trainees and Types of Trainees

The number of trainees in the training depends on the role each trainee is assigned. There are two types of trainees: Hands-on Trainee and Observer Trainee Hands-on Trainee Hands-on trainees handle the computer and arm. n the steps we show below, many of the actions are hands-on practice. If we have 3 trainees, then the step will require 3 iterations. If we have 5 trainees, then the step will require 5 iterations. Having too many students in the hands-on training may limit how much information we can give. The fewer the number of hands-on trainees, the faster training goes. Observer Trainee If you limit some of the trainees to observers, then the training will move more quickly, and we will be able to teach more information.

Typical Training Agenda

Day 1

STEP	INSTALLATION / TRAINING TASK
1	Arm installation and setup
2	Bender integration assistance
3	Probe and scanner calibration
4	Setup a program from solid model
5	How to setup a program from a print
6	Arm connection and scanner setup
7	Measuring Cut Planes (measuring the table surface)
8	General measuring setup (set your default tolerances into VTube-LASER)
9	How to measuring the tube/pipe
10	Understanding the inspection results to qualify the tube shape
11	Using BENDER SETUP to connect to benders for setup and correction
12	How to view reports
13	How to reverse-engineer a tube
14	Address any unique application needs
15	Hands-on practice for students

Day 2

STEP	INSTALLATION / TRAINING TASK
1	Review what we learned on day 1 - quiz the trainees
2	Practice full corrections loops with actual customer parts
3	Review special application needs

Other Pages

• Back to VTube-LASER