Cable Spec 33

From ATTWiki
Revision as of 21:00, 17 September 2012 by Mcone (Talk | contribs)

Jump to: navigation, search

For use inside Benderlink Ethernet Modules with current loop electronics.

Cable33 closeup.jpg

Use for simulating the PREMIER (Bender) side only.

Cable33.jpg

Wiring schematic:
Cable 33 wire scheme.jpg

CB-EL1 Board Setup For Use With Cable 33

In this configuration, it is necessary to use a version 2 CB-EL1 board with the jumpers set to "BND" to simulate the bender side of the connection. Use this setup for connecting a non Eaton Leonard bender to an Eaton Leonard Vector measuring center.

The original CB-EL1 board (without jumpers) can only handle the Vector measuring center side connection. Do not use v1 in this configuration.

Cb-el1 bendermode.jpg

Other Pages