VTube-LASER Training Agenda

Back to VTube-LASER

About the Training Agenda

Training agendas for VTube-LASER usually follow the pattern shown below. We often adjust the training depending on the customer's application needs.

Number of Students

There are two types of trainees: Hands-on Trainee, and Observer Trainee The fewer the number of hands-on trainees, the faster training goes. In the steps we show below, many of the actions are hands-on practice. If we have 3 trainees, then the step will require 3 iterations. If we have 5 trainees, then the step will require 5 iterations. Having too many students in the hands-on training may limit how much information we can give. If you have multiple trainees - but limit some of them to observers, then the training will move more quickly.

Typical Training Agenda

Day 1

STEP	INSTALLATION / TRAINING TASK
1	Arm installation and setup
2	Bender integration assistance
3	Probe and scanner calibration
4	Setup a program from solid model
5	How to setup a program from a print
6	Arm connection and scanner setup
7	Measuring Cut Planes (measuring the table surface)
8	General measuring setup (set your default tolerances into VTube-LASER)
9	How to measuring the tube/pipe
10	Understanding the inspection results to qualify the tube shape
11	Using BENDER SETUP to connect to benders for setup and correction
12	How to view reports
13	How to reverse-engineer a tube
14	Address any unique application needs
15	Hands-on practice for students

Day 2

STEP	INSTALLATION / TRAINING TASK
1	Review what we learned on day 1 - quiz the trainees
2	Practice full corrections loops with actual customer parts
3	Review special application needs

Other Pages

• Back to VTube-LASER