Difference between revisions of "VTube NUMALLIANCE Bender Correction"
From ATTWiki
(→NUMALLIANCE CORRECTIONS) |
|||
| Line 19: | Line 19: | ||
==NUMALLIANCE CORRECTIONS== | ==NUMALLIANCE CORRECTIONS== | ||
| + | |||
| + | <table cellpadding=10 width=1200> | ||
| + | <tr valign=top> | ||
| + | |||
| + | <td width=300> | ||
| + | VTube-LASER has an export option for NUMALLIANCE CSV files that is used to '''correct''' the NUMALLIANCE benders.<br><br> | ||
| + | Note: NUMALLIANCE benders only require the ''measured'' data for corrections.<br><br> | ||
| + | Measure the tube in VTube-LASER, then send the MEASURED tube data to the bender control, and it will then perform the correction. | ||
| + | |||
| + | </td> | ||
| + | |||
| + | <td> | ||
| + | [[image:NumallianceCorrectionsSlide1.png|800px]] | ||
| + | </td> | ||
| + | </tr> | ||
| + | |||
| + | </table> | ||
| + | <br><br> | ||
| + | |||
| + | |||
| + | |||
| + | ==STEP 1== | ||
<table cellpadding=10 width=1200> | <table cellpadding=10 width=1200> | ||
Revision as of 15:09, 15 July 2019
|
This page describes how to use VTube-LASER to correct NUMALLIANCE benders. |
Back to VTube-LASER
Contents |
NUMALLIANCE CORRECTIONS
|
VTube-LASER has an export option for NUMALLIANCE CSV files that is used to correct the NUMALLIANCE benders. |
|
STEP 1
|
VTube-LASER has an export option for NUMALLIANCE CSV files that is used to correct the NUMALLIANCE benders. |
|
Other Pages
- See VTube-LASER
- See VTube-STEP
