Difference between revisions of "About VTube-LASER End Angle Qualification"

From ATTWiki
Jump to: navigation, search
(→‎Set the Datum)
(→‎Datum Reports)
Line 30: Line 30:
 
</td>
 
</td>
  
−
</tr>
 
−
 
−
</table>
 
−
<br><br>
 
−
 
−
==Datum Reports==
 
−
 
−
<table cellpadding=10 width=900>
 
−
 
−
<tr valign=top>
 
−
<td width=300>
 
−
After a measure and alignment, use one of the Datum reports in the report menu to show the dimensions.<br><br>
 
−
In this example, the two X values show the dimensions that correspond to the 5.5 dimension.
 
−
</td>
 
−
<td>
 
−
[[image:datumreporttemplate.png|500px]]<br><br>
 
−
[[image:datumreport1.png|500px]]<br><br>
 
−
[[image:datumreport2.png|500px]]<br><br>
 
−
</td>
 
 
</tr>
 
</tr>
  

Revision as of 22:56, 22 March 2019

Vtube-laser logo 1.96.png


About VTube-LASER End Engle Qualifications

Vtube-laser v2.7 screenshot.png


Sample Print

The end angle deviation is the total angle the measured centerline end length varies from the master end length in degrees.

VTube-LASER includes end-angle qualifications because GMC used to include +/- 1 degree for the end-length qualification.

However, it is our opinion that this qualification is redundant because the end lengths are already qualified in the tangent-midpoint-tangent grid. In general, it is better to qualify a tube shape using linear units than polar (angular) units.

EndAngleDeviations.png



Other Pages

Retrieved from "http://www.advancedtubular.wiki/index.php?title=About_VTube-LASER_End_Angle_Qualification&oldid=39875"