Difference between revisions of "VTube-LASER Near Pass Deviation"
From ATTWiki
(→How it is used) |
(→How it is used in VTube-LASER) |
||
| Line 12: | Line 12: | ||
===How it is used in VTube-LASER=== | ===How it is used in VTube-LASER=== | ||
| − | <table | + | <table valign=top> |
<tr> | <tr> | ||
<td width=300> | <td width=300> | ||
Revision as of 14:19, 17 September 2018
Nearest Pass Explanation
|
The point at which two 3D lines are the closest to each other is where they come closest to intersecting. The distance is the “nearest pass.” |
|
How it is used in VTube-LASER
|
VTube-LASER checks for and displays the Nearest Pass value when measuring two intersecting tube straights. If the value is too high, then VTube-LASER will ask you to remeasure the tube until the value is within tolerance. The default tolerance for Nearest Pass is 2mm. |
|
