Difference between revisions of "VTube-LASER Cut Planes"
(→STEP 2) |
(→STEP 2) |
||
Line 45: | Line 45: | ||
<td> | <td> | ||
[[image:vtube-laser_cutplane_step2.png|400px]] | [[image:vtube-laser_cutplane_step2.png|400px]] | ||
+ | </td> | ||
+ | </tr> | ||
+ | <tr> | ||
+ | <td width=300> | ||
+ | |||
+ | |||
+ | ===STEP 3=== | ||
+ | Move the probe to another place on table in a way that forms an approximate equilateral triangle. (It is best to not make the triangle a thin sliver triangle.<br><br> | ||
+ | Press and release the green button.</td> | ||
+ | <td> | ||
+ | [[image:vtube-laser_cutplane_step3.png|400px]] | ||
</td> | </td> | ||
</tr> | </tr> |
Revision as of 22:24, 4 September 2015
|
About Cut Planes
Cut planes allow VTube-LASER to define a plane of a table or other surface in order to cut laser points from being used in measurements to VTube-LASER.
How to Create a Cut Plane
Cut planes are created with four measurements with the ball probe.
STEP 1In VTube-LASER click on Measure Process, then click on Measure Cut Plane. The Laser scanner will turn off automatically. |
|
STEP 2Move the probe to another place on table. The further away from the first point, the better for the math engine. |
|
STEP 3Move the probe to another place on table in a way that forms an approximate equilateral triangle. (It is best to not make the triangle a thin sliver triangle. |
|
STEP 3Select the correct ball probe then press OK. |
|
STEP 4Press the Close button in the FARO Arm Utilities window. |
|
STEP 5Observe that the new ball probe selection will appear in the Arm grid. |
Other Pages
- Back to the VTube-LASER page