Difference between revisions of "VTube-LASER v1.62"
| Line 25: | Line 25: | ||
<td width=300> | <td width=300> | ||
[[image:vtube-laser_endscan_progresswindow.jpg|300px]]<br><br> | [[image:vtube-laser_endscan_progresswindow.jpg|300px]]<br><br> | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
| + | |||
| + | <br><br> | ||
| + | |||
| + | |||
| + | ===[[image:Check.jpg|25px]] NEW: Scan Rate Types: Timer or Distance=== | ||
| + | <table cellpadding=10> | ||
| + | <tr valign=top> | ||
| + | <td width=200> | ||
| + | Now all scan rates are determined by either a TIMER or a DISTANCE. | ||
| + | <br><br> | ||
| + | For end-scans, use a timer and set the timer value to 0 milliseconds.<br><br> | ||
| + | For cylinder scans, you can use DISTANCE and set the Cylinder Scan Distance to whatever value is convenient for separation. | ||
| + | </td> | ||
| + | <td width=300> | ||
| + | [[image:vtube-laser_measuresetup_scanrates.jpg|300px]]<br><br> | ||
</td> | </td> | ||
</tr> | </tr> | ||
Revision as of 05:11, 12 March 2011
|
Revision 1.62Back to VTube-LASER |
|
ENHANCED: End Scans Faster
|
Analysis of end scans is now much faster.
|
|
NEW: Scan Rate Types: Timer or Distance
|
Now all scan rates are determined by either a TIMER or a DISTANCE.
|
|
NEW: Multiple Point Qualification End Scan
|
VTube-LASER now uses multiple points to qualify the end-scan. This gives it better protection against outlier points. |
|
REPAIR: Diameter and Wall Detection for STEP Mode
| See VTube-STEP v1.62 for details. |
|
Other Changes
Issues with this version fixed in next version
|
Other Pages
- Back to VTube-LASER
