Difference between revisions of "Mandrel Lube"
(→Where is the Mandrel Lube Option?) |
(→Mandrel Lube Start and Stop) |
||
| Line 44: | Line 44: | ||
==Mandrel Lube Start and Stop== | ==Mandrel Lube Start and Stop== | ||
| + | <table> | ||
| + | <tr> | ||
| + | <td width=300> | ||
This feature works with the Mandrel Lube Start and Mandrel Lube Stop angle settings. These control the start and stop of the mandrel lube based upon the bend angle. | This feature works with the Mandrel Lube Start and Mandrel Lube Stop angle settings. These control the start and stop of the mandrel lube based upon the bend angle. | ||
| + | <br><br> | ||
| + | The start angle refers to where the lube zone starts: The values is from 0 degrees. | ||
| + | <br><br> | ||
| + | The stop angle refers to where the lube zone ends: The value an angle below the FINAL ANGLE. If you set this value to 50 degrees, and your bend angle is 50 degrees, then the lube will never start - because CNC Bender is told to stop the lube 50 degrees below the goal - which is 0 degrees. | ||
| + | </td> | ||
| + | <td> | ||
| + | [[image:mandrellubesetstart.jpg|400px]]<br><br> | ||
| + | [[image:mandrellubesetstop.jpg|400px]] | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
Revision as of 22:54, 30 December 2009
|
|
|
Contents |
Where is the Mandrel Lube Option?
|
The lube feature is only available inside the Bend Option cells of the FRB menu. This allows an operator to control mandrel lube for each bend.
|
|
Mandrel Lube Start and Stop
|
This feature works with the Mandrel Lube Start and Mandrel Lube Stop angle settings. These control the start and stop of the mandrel lube based upon the bend angle.
|
|
