Difference between revisions of "Modicon Momentum"
From ATTWiki
| Line 8: | Line 8: | ||
<table> | <table> | ||
| + | |||
| + | <tr> | ||
| + | <td width="200"> | ||
| + | This is the form for the I2T servo modules | ||
| + | </td> | ||
| + | <td> | ||
| + | [[image:momentum.jpg|300px]] | ||
| + | </td> | ||
| + | </tr> | ||
| + | |||
<tr> | <tr> | ||
<td width="200"> | <td width="200"> | ||
| Line 16: | Line 26: | ||
</td> | </td> | ||
</tr> | </tr> | ||
| + | |||
</table> | </table> | ||
Revision as of 20:59, 20 February 2009
This the form of the modules that are installed to SMT CNC Bender. For example, the I/O module is shown above.
See this brochure for an overview of this device.
They mount to DIN rails in electrical panels.
|
This is the form for the I2T servo modules |
|
|
In the I2T servo modules, the serial port is an RJ-45 receptacle port shown in this image. |
|
Other Pages
- Back to CNC Bender page
- Back to CNC Bender General Information page
- Back to CNC Bender Technical Notes page
