Difference between revisions of "Modicon Momentum"
From ATTWiki
| Line 5: | Line 5: | ||
They mount to [http://en.wikipedia.org/wiki/DIN_rail DIN] rails in electrical panels. | They mount to [http://en.wikipedia.org/wiki/DIN_rail DIN] rails in electrical panels. | ||
| + | |||
| + | <table> | ||
| + | <tr> | ||
| + | <td width="200"> | ||
| + | The Momemtum serial port is an RJ-45 receptacle port shown in this image. (The image above does not show a port.) | ||
| + | </td> | ||
| + | <td> | ||
| + | [[image:momentum_serial_port.jpg|300px]] | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
Revision as of 20:47, 20 February 2009
These are the I/O modules used in the CNC Benders.
See this brochure for an overview of this device.
They mount to DIN rails in electrical panels.
|
The Momemtum serial port is an RJ-45 receptacle port shown in this image. (The image above does not show a port.) |
|
Other Pages
- Back to CNC Bender page
- Back to CNC Bender General Information page
- Back to CNC Bender Technical Notes page
