Difference between revisions of "VTube-LASER Near Pass Deviation"
From ATTWiki
(→Nearest Pass Explanation) |
|||
| Line 1: | Line 1: | ||
| + | <table> | ||
| + | <tr cellpadding=10> | ||
| + | <td width=225> | ||
| + | [[image:vtube-laser_logo_1.96.png|200px]] | ||
| + | * Back to [[VTube-STEP]] | ||
| + | * Back to [[VTube-LASER]] | ||
| + | </td> | ||
| + | <td width=300> | ||
| + | [[image:vtl_screen_hd_scanner_without_logo.png|300px]] | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
| + | |||
| + | __NOTOC__ | ||
| + | |||
| + | |||
| + | |||
===Nearest Pass Explanation=== | ===Nearest Pass Explanation=== | ||
<table> | <table> | ||
Revision as of 14:21, 17 September 2018
|
|
|
Nearest Pass Explanation
|
The point at which two 3D lines are the closest to each other is where they come closest to intersecting. The distance is the “nearest pass.” |
|
How it is used in VTube-LASER
|
VTube-LASER checks for and displays the Nearest Pass value when measuring two intersecting tube straights. If the value is too high, then VTube-LASER will ask you to remeasure the tube until the value is within tolerance. The default tolerance for Nearest Pass is 2mm. |
|
