Difference between revisions of "VTube-LASER Training Agenda"
From ATTWiki
(→Day 1) |
(→Day 1) |
||
| Line 38: | Line 38: | ||
<tr valign=top> | <tr valign=top> | ||
| − | <td width=100> | + | <td width=100>STEP</td> |
| − | STEP | + | <td>INSTALLATION / TRAINING</td> |
| − | </td> | + | </tr> |
| + | |||
| + | <tr valign=top> | ||
| + | <td>1</td> | ||
<td> | <td> | ||
| − | + | Arm installation and setup | |
</td> | </td> | ||
</tr> | </tr> | ||
<tr valign=top> | <tr valign=top> | ||
| − | <td | + | <td> |
| − | + | 2 | |
</td> | </td> | ||
<td> | <td> | ||
| − | + | Bender integration assistance | |
</td> | </td> | ||
</tr> | </tr> | ||
<tr valign=top> | <tr valign=top> | ||
| − | <td | + | <td> |
| − | + | 3 | |
</td> | </td> | ||
<td> | <td> | ||
| − | + | Probe and scanner calibration | |
</td> | </td> | ||
</tr> | </tr> | ||
| + | |||
</table> | </table> | ||
Revision as of 15:53, 28 September 2017
|
|
|
Contents |
About theTraining Agenda
|
Training agendas for VTube-LASER usually follow the pattern shown below. |
Typical Training Agenda
Day 1
| STEP | INSTALLATION / TRAINING |
| 1 |
Arm installation and setup |
|
2 |
Bender integration assistance |
|
3 |
Probe and scanner calibration |
Other Pages
- Back to VTube-LASER
