Difference between revisions of "VTube-LASER v2.8"
(→NEW BACKUP CREATED) |
(→25px ENHANCED: Winton WMC Communications Improvement) |
||
| Line 92: | Line 92: | ||
Immediately after the user presses the Exit and Save setup data button, this dialog appears (see step 4 below):<br><br> | Immediately after the user presses the Exit and Save setup data button, this dialog appears (see step 4 below):<br><br> | ||
[[image:vtl_v2.8_winton_correction_overwrite_backup_dialog.png|400px]]<br><br> | [[image:vtl_v2.8_winton_correction_overwrite_backup_dialog.png|400px]]<br><br> | ||
| + | </tr> | ||
| + | </table> | ||
| + | <br><br> | ||
| − | |||
| − | |||
| + | <table cellpadding=10 width=900> | ||
| + | <tr valign=top> | ||
| + | <td width=300> | ||
| + | This is an image that shows the overall process for correction of Winton WMC files. | ||
| + | <br><br> | ||
| + | <td> | ||
| + | </td> | ||
| + | <td> | ||
| + | [[image:vtl_v2.8_winton_correction_process.png|600px]]<br><br> | ||
</tr> | </tr> | ||
</table> | </table> | ||
Revision as of 01:14, 4 March 2017
|
Revision 2.8Release Date: Not Released
|
|
Contents |
BUILD 11 - February 15, 2017
NEW: "Default Tolerance Ends" Value
|
The Default Tolerance Ends value is in the Inspection Data menu.
|
|
NEW: REPORT COMMANDS - Tangent Deviation AVERAGE and MAXIMUM Values
|
Two new array values are available for reports: AVERAGE deviation and MAXIMUM deviation.
|
|
BUILD 19 - February 22, 2017
ENHANCED: Winton WMC Communications Improvement
|
The process for corrections to Winton WMC files were clarified with dialogs that make it very clear what VTube-LASER Bender Setup is doing during the Winton WMC correction process.
1 - NEW HELP DIALOGSSteps 2 and 5 are new. They carefully explain what is happening during the correction process. 2 - NEW BACKUP CREATEDStep 5 also explains that a BACKUP file is created during the process. This allows operators to always recover to the previous data if something goes wrong in the correction process. (The creation of a backup file is new in this version.)
|
Immediately after the user presses the Auto Correction button, this dialog appears (see step 2 below): Immediately after the user presses the Exit and Save setup data button, this dialog appears (see step 4 below): |
|
This is an image that shows the overall process for correction of Winton WMC files.
|
|
NEW: REPORT COMMANDS - Tangent Deviation AVERAGE and MAXIMUM Values
|
Two new array values are available for reports: AVERAGE deviation and MAXIMUM deviation.
|
|
Other Pages
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See VTube-LASER Cut Planes
- See the tutorial on DCP - Diameter Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature
