Difference between revisions of "VTube-LASER Cut Planes"
From ATTWiki
(→How to Change the Default Ball Probe Setup) |
|||
| Line 14: | Line 14: | ||
| − | == | + | ==About Cut Planes== |
| − | + | Cut planes allow VTube-LASER to define a plane of a table or other surface in order to cut laser points from being used in measurements to VTube-LASER.<br><br> | |
| + | |||
| + | |||
| + | ==How to Create a Cut Plane== | ||
| + | Follow these steps to create a cut plane. | ||
| − | |||
<table> | <table> | ||
| Line 25: | Line 28: | ||
===STEP 1=== | ===STEP 1=== | ||
| − | In VTube-LASER click on | + | In VTube-LASER click on Measure Process, then click on Measure Cut Plane. The Laser scanner will turn off automatically.</td> |
<td> | <td> | ||
[[image:vtube-laser_v2.2_measuresetup_arm_armutilities.png|400px]] | [[image:vtube-laser_v2.2_measuresetup_arm_armutilities.png|400px]] | ||
Revision as of 20:52, 4 September 2015
|
|
|
About Cut Planes
Cut planes allow VTube-LASER to define a plane of a table or other surface in order to cut laser points from being used in measurements to VTube-LASER.
How to Create a Cut Plane
Follow these steps to create a cut plane.
STEP 1In VTube-LASER click on Measure Process, then click on Measure Cut Plane. The Laser scanner will turn off automatically. |
|
STEP 2Press Probe Setup and Calibration. |
|
STEP 3Select the correct ball probe then press OK. |
|
STEP 4Press the Close button in the FARO Arm Utilities window. |
|
STEP 5Observe that the new ball probe selection will appear in the Arm grid. |
|
Other Pages
- Back to the VTube-LASER page
