Difference between revisions of "VTube Rectangular Tubes"

• Back to VTube-STEP
• Back to VTube-LASER

VTube can draw rectangular or square tubing. The dimensional controls are in the Part Setup menu of both STEP and LASER modes:

Square Tube

Set Width1 and Width2 to the same values to draw square tube.

The rectangular fillet radius controls the four corner radii.

Rectangular - Bending "Easy Way"

This profile orientation is referred to as the "easy way" bending in the tubing industry. The reason is because this orientation is easier to bend than a profile rotated 90 degrees to this.

Rectangular - Bending "Hard Way"

You can switch the values in the Width1 and Width2 to rotate the tube shape into the "hard way" bending method.

Square Tube Rotation

Rectangular Tube Rotation

VTube can calculate the centerline of rectangular tube solid models. The operator imports the STEP and IGES model, collects the fillet corners of a rectangular shape to calculate the centerline of the rectangular solid model, then calculates the centerline.

• OUTER DIAMETER SELECTION:Three fillets are selected in each straight's out diameter. This will calculate the centerline.
  
  

• WALL THICKNESS: The wall thickness can also be extracted from the model by selecting one of the inner diameter fillets in any straight.
  
  

• RECTANGULAR PROFILE: If possible, VTube will calculate the rectangular profile, and the profile start angle to the first bend plane.
  
  

VTube measures rectangular and square tube shapes with the laser or ball probes.

• FILLET EDGE DETECTION:The laser scanning feature includes edge detection in order to remove the fillet from the plane calculations. In this image, see how VTube detects edge fillets and removes them automatically from the calculation of the planes.
  
  

• TRUE CENTERLINE LOCATION: The process and logic automatically calculates the location of the centerline from the true surface data. The nominal width data is not needed to find the centerline.
  
  

• OVAL TUBE with FLAT SIDES: VTube can also measure rectangular oval tube shapes with large radius edges using a ball probe. (This profile shape of tube is often used on exercise equipement like [Cybex machines], and in custom exhaust like SpinTech Performance.)