Difference between revisions of "Cable Spec 35"
From ATTWiki
| Line 30: | Line 30: | ||
<table> | <table> | ||
<tr> | <tr> | ||
| − | <td width=150 align=right | + | |
| + | <td width=150 align=right> | ||
Yellow | Yellow | ||
</td> | </td> | ||
| Line 72: | Line 73: | ||
8 | 8 | ||
</td> | </td> | ||
| + | |||
| + | <td width=150 align=left> | ||
| + | 2 | ||
| + | </td> | ||
| + | <td width=50 align=left> | ||
| + | RXD | ||
| + | </td> | ||
| + | </tr> | ||
| + | |||
| + | <tr> | ||
| + | <td width=150 align=left> | ||
| + | 3 | ||
| + | </td> | ||
| + | <td width=50 align=left> | ||
| + | TXD | ||
| + | </td> | ||
| + | </tr> | ||
| + | |||
| + | <tr> | ||
| + | <td width=150 align=left> | ||
| + | 5 | ||
| + | </td> | ||
| + | <td width=50 align=left> | ||
| + | GND | ||
| + | </td> | ||
| + | </tr> | ||
| + | |||
| + | <tr> | ||
| + | <td width=150 align=left> | ||
| + | 7 | ||
| + | </td> | ||
| + | <td width=50 align=left> | ||
| + | RTS | ||
| + | </td> | ||
| + | </tr> | ||
| + | |||
| + | <tr> | ||
| + | <td width=150 align=left> | ||
| + | 8 | ||
| + | </td> | ||
| + | <td width=50 align=left> | ||
| + | CTS | ||
| + | </td> | ||
| + | |||
</tr> | </tr> | ||
Revision as of 14:13, 23 May 2012
|
This is the wiring schematic for the RJ45 to DB9 female adapter for the CB-EL1 RS232D port on the board. |
|
RJ45 Plug Side |
|
DB9 Female Side |
||||||||||||||||||
|
|
This is an image of an RJ45 to DB9 adapter with the above wiring. The DB9 port is female to attach to a standard PC male port. |
|
|
|
